Ei Electronics Ei168RC Instruction Manual

Instruction ManualRead and retain carefully for as long as the product is being used. It contains vital information on the operation and installation

To complete the commissioning, the system must exit house code mode.The units will automatically exit house code after 30 minutes. Once coded the syst

Slide the Alarm Controller onto the mounting base on the wall.Check that the RadioLINK system is working by pressing the button on the Alarm Controlle

Reset the house codeSometimes in order to resolve an RF communication issue, e.g. Alarms have to be relocated, it may necessary to reset and house cod

4. OperationFrequent testing of the system is advised to ensure its continued and safe operation. Guidelines and best practices for testing are as fol

Remove the Alarm Controller from its cradle. If the unit has been tamper proofed you will need to release the latch with a screwdriver.With the Alarm

If there is a fire, immediately evacuate the premises and telephone the fire brigade.If the source of the alarm is not obvious go to the Alarm Control

If you are satisfied there is no fire but the Smoke/Heat Alarm is still continuing to alarm you may now silence the system.Wait until the SILENCE segm

17is flashing. If the button is not pressed within 10 seconds the FIRE indicator stops flashing, the Alarms stop sounding and the memory is erased.The

5. GuaranteeEi Electronics guarantees this Alarm Controller for 5 years from date of purchase against any defects that are due to faulty materials or

6. Troubleshooting the RadioLINKIf, when checking the RadioLINK interconnection, some of the Alarms do not respond to the Alarm Controller remote cont

Contents1. Overview ...

7. Technical SpecificationSupply Voltage Powered for life Lithium batteryBattery Capacity 1600 mAhRF Frequency 868.499MhzTemperature Specific

8. Getting the Alarm Controller servicedIf your Alarm Controller fails to work after you have carefully read all the instructions and checked that the

9. Product UpdatesAs part of our continuous improvement policy, product performance and features are being frequently updated. These updates include “

23The crossed out wheelie bin symbol that is on your product indicates that this product should not be disposed of via the normal househo

Aico LtdMile End Business Park,Maesbury Road, Oswestry,Shropshire SY10 8NN, U.K.Telephone: 0870 7584000www.aico.co.ukEi ElectronicsShannon Industrial

1. OverviewCongratulations on purchasing the single button Alarm Controller for RadioLINK Fire and Carbon Monoxide (CO) Alarm systems. The Alarm Contr

Fire / CO Alarm ControllerFire Indicator Low Battery Indicator CO IndicatorLight Segments (4) Test / Control Button4

Wireless Smoke Alarm System Wireless Smoke &Carbon Monoxide Alarm SystemRF Smoke AlarmRF Smoke AlarmRF Smoke AlarmAlarm ControllerRF Smoke AlarmRF

2. InstallationInstall the Alarm Controller mounting plate at an accessible point on the wall 1.4M +/- 200mm from floor level. Consider an alternative

Power up sequenceFIRE, BATTERY & CO indicators flashEach individual segment lights up redEach individual segment lights blueEach individual segmen

3. House CodingIt is essential to House Code the Alarm Controller to all the other RadioLINK Alarms and devices in the system to ensure they will not

Return to the Alarm Controller and check that all segments (ring) are flashing blue. The number of flashes should equal the number of RadioLINK Alarms