Ei Electronics Ei168RC Instruction Manual download pdf (Page 19)

6. Troubleshooting the RadioLINK

If, when checking the RadioLINK interconnection, some of the Alarms do not respond to the Alarm

Controller remote control test, then:

(i) Ensure the Alarm Controller has been activated correctly. Check that the power on procedure operates

as described in the ‘Installation’ section.

(ii) Repeat House Code procedure (see ‘House Coding’ section).

(iii) Relocate the Alarm Controller and/or rotate/relocate the RadioLINK Alarms. There are a number of

reasons why the RadioLINK signals may not reach all the Alarms in your system. Try rotating the Alarms

or relocating the Alarms (e.g. move them away from metal surfaces or wiring) as this can significantly

improve signal reception.

Rotating and/or relocating the Alarms may move them out of the range of existing units even though

they may have already been House Coded correctly in the system. It is therefore important to check that

all Alarms are communicating in their final installed positions. If Alarms are rotated and/or relocated,

we recommend that all Alarms are returned to the factory settings (see the respective use and care

instructions). Then House Code all Alarms again in their final positions. The RadioLINK interconnection

should then be checked again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Ei Electronics Ei168RC Instruction Manual Page 19