Ei Electronics Ei262 Specifications download pdf (Page 18)

If interconnected CO and Smoke/Heat Alarms are all sounding, the

LOCATE switch on the Ei411H3 Remote Control should be pressed. This

will just leave the alarm that triggered the system sounding.

This is very important to determine because the actions to take in each

situation are very different.

In the case of CO the premises should be fully ventilated by opening doors

and windows. The user should call the gas supplier etc.

In the case of fire, doors and windows should be closed to slow the spread

of fire. The user should call the fire brigade etc.

2. Wirelessly communicate with Ei Electronics RadioLINK accessories

such as the Ei428 RadioLINK Relay (e.g. for shutting off gas valves) and

the Ei411H3 Remote Control.

4.2.1 Interconnection

After all the RadioLINK devices have been installed they must all be house

coded as follows:

Housecoding your alarm

1. Press and hold the housecode switch on the bottom of the cover with a small screwdriver until the

green power light turns red (see figure 7).

2. Immediately release the switch and the light will flash red (alternating with green) quickly a few times.

The red light will then flash every 5 or 10 seconds (depending on number of units coded - see below).

Repeat this action on all other RadioLINK Ei262 units in the property as quickly as possible (within 15

minutes).

3. Now put any other RadioLINK devices in the property into house code mode (see their separate

instruction manuals for details) within 15 minutes.

HOUSECODE

SWITCH

GREEN POWER LIGHT TURNS

RED FOR RADIOLINK INDICATION

House

Code

Figure 7

B16587-R0-262-UC-ENG 15/4/09 3:38 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

Ei Electronics Ei262 Specifications Page 18