Ei Electronics Ei262 Specifications download pdf (Page 33)

Audible Alarm : 85dB(A) minimum @ 3m

Self Diagnostics

Sensor : Horn beep and amber fault light flashes every 40 seconds if a sensor fault is found.

Rechargeable : Fully charged cells can power unit in standby for over 4 weeks and without

Lithium Cells: mains power, it can power the unit in alarm for over 2 hours. The unit beeps

every 40 seconds if cells are depleted.

Tamperproof : Screwdriver needed to release from mounting plate. Additionally a tamper-

proofing screw can be fitted to the mounting plate.

Hardwired Interconnect : Up to 12 Ei262 CO Alarms can be interconnected, so that when one senses

CO, all alarm. Alternatively, up to a combined total of 12 Ei262 CO Alarms

and Ei161RC/Ei164RC/Ei166RC/Ei2110/Ei261RC Smoke/Heat/Fire Alarms

can be interconnected provided that an Ei1529RC Remote Control is used.

Wireless Interconnect : Up to 12 Ei262 CO Alarms can be interconnected, so that when one senses

CO, all alarm. Alternatively, up to a combined total of 12 Ei262 CO Alarms

and Ei161RC/Ei164RC/Ei166RC/Ei2110 Smoke/Heat/Fire Alarms on an

Ei168RC RadioLINK base can be interconnected provided that an Ei411H3

Remote Control is used.

CO Alarm Memory: : A unit will indicate if it has been in alarm previously by flashing the red light

for 2 seconds every 40 seconds (2 flashes for 50 ppm CO, 4 flashes for 100

ppm CO and 8 flashes, for 300 ppm CO). When the Test/Hush button is

pressed, the red light flashes (as per Table B) to indicate the previous CO

alarm level detected. The memory is cleared by holding down the Test/Hush

button until the red light stops flashing.

B16587-R0-262-UC-ENG 15/4/09 3:38 PM Page 33

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Ei Electronics Ei262 Specifications Page 33