Ei Electronics Ei262 Specifications download pdf (Page 37)

1. ALARM DOES NOT WORK WHEN THE TEST BUTTON IS PRESSED:

- Check that the green mains power light is on. If it is off check the wiring, fuse, circuit breakers etc.

- Hold the Test/Hush button down for at least 5 seconds.

- Turn off mains power, remove from mounting plate (see figure 4) for 3 minutes and re-install (this resets

the alarm).

2. ALARM BEEPS AND AMBER LIGHT FLASHES EVERY 40 SECONDS:

- If the alarm beeps and the amber fault light flashes every 40 seconds, the CO sensor is probably

defective.

- Press the Test/Hush button for approximately 20 seconds to reset the unit. If the beeping and the amber

light flashing re-occurs replace the sensor module.

3. ALARM BEEPS EVERY 40 SECONDS (without amber light flashing):

- Rechargeable cells depleted. Reconnect mains power if green light is off.

4. ALARM SOUNDS FOR NO APPARENT REASON:

Follow the detailed instructions in Section 1 on page 4 entitled “WHAT TO DO WHEN THE ALARM

SOUNDS”. If there are still problems:

- Ensure there are no fuel-burning appliances in the vicinity which could be leaking CO gas (e.g. even

from next door).

- Ensure there are no fumes in the area (e.g. paint, thinners, alcohol, hair spray, chemical cleaners

aerosol sprays etc).

- Ensure there is no outdoor source of CO in the vicinity (e.g. a car with engine running, heavy traffic,

heavy air pollution, barbecue fumes etc).

- Press the Test/Hush button to silence the alarm.

B16587-R0-262-UC-ENG 15/4/09 3:38 PM Page 37

1 2 ... 32 33 34 35 36 37 38 39 40

No comments

Ei Electronics Ei262 Specifications Page 37